Network

Howto set up a Wireless Bridge in Debian

 Network  No Responses »
Dec 012008
 

    A wireless router is great when toting a computer with a wireless interface around, but moving a wired computer to another room or floor often means stringing an unsightly Ethernet cable through the house. The alternative is buying a wireless adapter, hoping that a Linux driver is available for it (there often isn't). Even a wireless interface is no good when used out of range of the wireless router.
    Continue reading »

    Incoming search terms:

       Posted by at 12:02 am

      Netgear WG111T working with Debian Etch and Lenny

       Network  2 Responses »
      Nov 212008
       

        This tutorial will explain how to working with Netgear WG111T working with Debian Etch and Lenny

        Continue reading »

        Incoming search terms:

           Posted by at 12:01 am

          How to configure Cisco SPAN Ports

           Network  2 Responses »
          Sep 282008
           

            The following example will demonstrate how to configure a single SPAN session on a Cisco Catalyst switch. The specifics are different between different switch models, so be sure to check the Cisco documentation.

            Continue reading »

            Incoming search terms:

               Posted by at 12:03 am

              Fix for High CPU usage when SNMP is enabled in Cisco Routers

               Network  No Responses »
              Sep 042008
               

                Cisco Routers and Switches with L3 routing functions are seen to have problems with High CPU usage when SNMP is enabled. This can range anything from 15% to 40%. According to Cisco, these are low priority processes and other priority processes requiring CPU cycles are given priority over these processes and this level of CPU utilisation can be is normal. However, it is always better to be safe than sorry and get the CPU utilisation caused by SNMP to bare minimum so as to ensure the Routers function smoothly.

                Continue reading »

                Incoming search terms:

                   Posted by at 12:19 am

                  Howto setup DHCP Server and Dynamic DNS with BIND in Debian

                   General, Network  19 Responses »
                  Jul 232008
                   

                    This tutorial will explain Howto setup DHCP Server and Dynamic DNS with BIND in Debian.

                    Preparing you system

                    First you need to install DHCP,BIND servers using the following command

                    Continue reading »

                    Incoming search terms:

                       Posted by at 12:03 am
                       Older Entries  Newer Entries
                      QR Code Business Card