Search Results : configure » Page 8

Howto set up a Wireless Bridge in Debian

 Network  No Responses »
Dec 012008
 

A wireless router is great when toting a computer with a wireless interface around, but moving a wired computer to another room or floor often means stringing an unsightly Ethernet cable through the house. The alternative is buying a wireless adapter, hoping that a Linux driver is available for it (there often isn't). Even a wireless interface is no good when used out of range of the wireless router.
Continue reading »

Incoming search terms:

 Posted by at 12:02 am

Create a LAN for Virtual Servers with KVM and VDE

 General  2 Responses »
Nov 012008
 

Scenario: You have one host [ hoster ] running KVM on UBUNTU with 1 network interface accessing to internet.

You want to have 2 debian etch virtual servers [ guest ] ( debian01 and debian02 ) running on your hoster with network access between them and hoster in a local LAN. In this case virtual servers will not be able to access to internet, but later I will explain how to do it.

Continue reading »

Incoming search terms:

 Posted by at 12:02 am

How to configure Cisco SPAN Ports

 Network  2 Responses »
Sep 282008
 

The following example will demonstrate how to configure a single SPAN session on a Cisco Catalyst switch. The specifics are different between different switch models, so be sure to check the Cisco documentation.

Continue reading »

Incoming search terms:

 Posted by at 12:03 am

Fix for High CPU usage when SNMP is enabled in Cisco Routers

 Network  No Responses »
Sep 042008
 

Cisco Routers and Switches with L3 routing functions are seen to have problems with High CPU usage when SNMP is enabled. This can range anything from 15% to 40%. According to Cisco, these are low priority processes and other priority processes requiring CPU cycles are given priority over these processes and this level of CPU utilisation can be is normal. However, it is always better to be safe than sorry and get the CPU utilisation caused by SNMP to bare minimum so as to ensure the Routers function smoothly.

Continue reading »

Incoming search terms:

 Posted by at 12:19 am

Running Vhosts With Apache2 mpm-itk On Debian

 Webserver  5 Responses »
Aug 272008
 

apache2-mpm-itk (just mpm-itk for short) is an MPM (Multi-Processing Module) for the Apache 2 web server. mpm-itk allows you to run each of your vhost under a separate uid and gid --- in short, the scripts and configuration files for one vhost no longer have to be readable for all the other vhosts.

Continue reading »

Incoming search terms:

 Posted by at 12:03 am
 Older Entries  Newer Entries
QR Code Business Card